Skip to main content
M
22-Sapphire I
MikeLockwood22-Sapphire I
22-Sapphire I
April 18, 2016
Question

ModelCheck - Regen Errors/Warnings

  • April 18, 2016
  • 1 reply
  • 1347 views

I've got ModelCheck pretty well dialed in now (and have good test models and drawings that violate each check for demo / discussion / training) - but continue to refine many checks, especially those that don't seem to work at first pass.

Please see attached if interested (labeled with pending tech support case number).  It shows a feature which will not regenerate, and the specific message in the message log, and the MC configuration which should find it - but MC reports no Regen Errors.  Note that MC was run in Interactive Regenerate mode for this.

thanks in advance for insight on this particular check


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

M
Mahesh_Sharma22-Sapphire I
22-Sapphire I
April 27, 2016

Mike,

Try adding

"W: Feature regeneration failed." in mc_regen.mcr and add REGEN_ERRS and REGEN_WRNS to error. And try ModelCHECK Regenerate

Terms & ConditionsCookie settingsAccessibility statement