Adding a existing creo model in windchill to a new family table

[SEaswaran2]

Hello all,

I have a screw released as an individual part in Windchill(released state). I have family table for screw. Can i add the new revision of standalone screw in Family Table ? is this possible without breaking existing relations of the screw in the assembly ?

[BenLoosli]

Not a trivial task, but can be done.

Check out this article, it may help:

https://www.ptc.com/en/support/article?n=CS4975&language=en&posno=2&q=add%20part%20to%20family%20table&source=search

But then PTC says this:

https://www.ptc.com/en/support/article?n=CS216690&language=en&posno=47&q=add%20part%20to%20family%20table&source=search