Question
... could not be saved to the workspace.
- July 2, 2009
- 1 reply
- 2611 views
I am working on Pro/Engineer Wildfire 4 with a pilot installation of Pro/Intralink 9.1.
I'm testing "what-if" functionality, where I'm modifying objects in my Workspace WITHOUT checking any of them out.
I opened up an assembly, then opened a part in the assembly. I changed a dimension, then a conflict window popped-up, prompting me to check-out the model. Since I didn't want to check-out the model, I chose Continue, instead. Then it let me change the dimension and regenerated the model.
I went back to the assembly and regenerated the assembly. I got a conflict warning - Read Only object regenerated (my assembly - OK so far).
I clicked Save for my assembly, and got a conflict about it - The object is read only as it is not checked out. I changed the Action to Continue, then clicked OK.
What I was expecting to happen is that the assembly and the part that I modified would get saved. Instead, the message window says that the assembly could not be saved to the workspace.
I looked at the message log, and there are 2 .xpr files that it says it could not save to the workspace. There are 3 other parts that it said could not be saved to the workspace (see attached). None of these were the part that I modified. The very last line is the assembly that I regenerated and was trying to save.
What's the "best" way to resolve this? As I said above, I am trying to avoid checking out anything. I also didn't actually modify anything in the subassembly that is 2nd from the bottom in the message log.
<<could not=" be=" saved=" to=" workspace.png=">>
Andrew Kelly, P.E. | Senior Engineer | Crane Aerospace & Electronics | +1 440 326 5555 | F: +1 440 284 1090
I'm testing "what-if" functionality, where I'm modifying objects in my Workspace WITHOUT checking any of them out.
I opened up an assembly, then opened a part in the assembly. I changed a dimension, then a conflict window popped-up, prompting me to check-out the model. Since I didn't want to check-out the model, I chose Continue, instead. Then it let me change the dimension and regenerated the model.
I went back to the assembly and regenerated the assembly. I got a conflict warning - Read Only object regenerated (my assembly - OK so far).
I clicked Save for my assembly, and got a conflict about it - The object is read only as it is not checked out. I changed the Action to Continue, then clicked OK.
What I was expecting to happen is that the assembly and the part that I modified would get saved. Instead, the message window says that the assembly could not be saved to the workspace.
I looked at the message log, and there are 2 .xpr files that it says it could not save to the workspace. There are 3 other parts that it said could not be saved to the workspace (see attached). None of these were the part that I modified. The very last line is the assembly that I regenerated and was trying to save.
What's the "best" way to resolve this? As I said above, I am trying to avoid checking out anything. I also didn't actually modify anything in the subassembly that is 2nd from the bottom in the message log.
<<could not=" be=" saved=" to=" workspace.png=">>
Andrew Kelly, P.E. | Senior Engineer | Crane Aerospace & Electronics | +1 440 326 5555 | F: +1 440 284 1090