Skip to main content
V
VladimirPalffy14-Alexandrite
14-Alexandrite
September 8, 2018
Question

Creo tutorial: How to Remove Ghost objects

  • September 8, 2018
  • 1 reply
  • 5037 views

 

In this tutorial, you can learn How to Remove Ghost objects from assembly - not stored ghosts anymore in PDM system:

 

This video was created based on question from a comment under my video on YouTube channel. Fell free to contact me or leave a comment, or idea for another Creo tutorial.

 

Vladimir Palffy - www.4kside.com

Tags: #proe #creo #creotutorial #tutorial #4kside #palffy #vpalffy #vladimirpalffy

    1 reply

    kdirth
    21-Topaz I
    kdirth21-Topaz I
    21-Topaz I
    September 24, 2018

    In the Replace dialog there is a check box for "Remember These Components"

    If you uncheck the box, the old reference will not be kept.

     

    I have changed my config option "remember_replaced_components" to no since maintaining the old reference is usually not important for me.

     

    If you think you might put the old part back in, remember these components will allow you to replace the new with the old without defining the references.

    There is always more to learn.
      V
      VladimirPalffy14-AlexandriteAuthor
      14-Alexandrite
      September 25, 2018

      Hi, thanks for your note but configuration option is:

       

      REMEMBER_REPLACED_COMPONENTS YES*/NO (where * is default)

       

      Terms & ConditionsCookie settingsAccessibility statement