Skip to main content
V
vincecatlin12-Amethyst
12-Amethyst
May 12, 2015
Solved

Where is my shrinkwrap?

  • May 12, 2015
  • 1 reply
  • 5115 views

Creo (and good old ProE) will add a shrinkwrap to a "models CAD document" by default.

I have NEVER actually found this mysterious location.

We have ALWAYS resorted to assigning different location just so we can find the darn thing.

I recently made a shrinkwrap and forgot to assign a different location and I'm genuinely curious as to where my shrinkwrap is.

I'm sure there is a simple answer to my simple question.

Thanks,

Vince

Best answer by HamsterNL

He's obviously having a hard day...let him vent... Smiley Wink

1 reply

V
vincecatlin12-AmethystAuthor
12-Amethyst
January 3, 2019

Seriously guys, thank you all very little for the zero answers in four freakin' years.

S
23-Emerald III
StephenW23-Emerald III
23-Emerald III
January 5, 2019

 

You apparently asked that question twice on the same day...

https://community.ptc.com/t5/Assembly-Design/Where-is-the-shrinkwrap/m-p/186361

And there was a response that you accepted as the solution.

Although you response was more the answer in that you look in the content tab of the part or assembly that you created the shrinkwrap from.

If you uncheck the box at the bottom of the "save a copy" dialog box, it will create the file in the workspace.

 

shrink.jpg

 

    HamsterNL
    HamsterNL18-OpalAnswer
    18-Opal
    January 9, 2019

    He's obviously having a hard day...let him vent... Smiley Wink

      Terms & ConditionsCookie settingsAccessibility statement