Skip to main content
V
vincecatlin12-Amethyst
12-Amethyst
May 12, 2015
Solved

Where is the shrinkwrap?

  • May 12, 2015
  • 2 replies
  • 2051 views

Honestly, it says right here that REV3 blah blah SW0002 HAS BEEN SAVED but a search fails to find it anywhere?

I know I could make another one but I should not have to!

WHERE HAS IT BEEN SAVED?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Best answer by MartinHanak

Vince,

(in Creo 2.0) just start creation of another shrinkwrap, discover target directory in Save a Copy dialog box and cancel the action.

Martin Hanak

2 replies

M
MartinHanak24-Ruby IIIAnswer
24-Ruby III
May 13, 2015

Vince,

(in Creo 2.0) just start creation of another shrinkwrap, discover target directory in Save a Copy dialog box and cancel the action.

Martin Hanak

C
ClintWalton1-Visitor
1-Visitor
May 27, 2015

Vince,

Did Martin's response resolve your question?

V
vincecatlin12-AmethystAuthor
12-Amethyst
June 2, 2015

Thanks Martin.

I also learned that when I allow the SW to be saved to the default location it's easy to find in Windchill in the "content" tab of the details page of the part or assembly.

In hindsight that one was pretty obvious.

We don't see an immediate need to have the shrinkwrap attached but maybe for a future reference model.

Terms & ConditionsCookie settingsAccessibility statement