Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X
Hi,Team.
In this trainning:
https://developer.thingworx.com/en/resources/learning-paths/getting-started-on-thingworx-platform/thingworx-foundation-quickstart/display-device-data
I can´t configurate the DATA GAUGE and DATA LINE CHART, like this pic.
I started the trainning couple times, and do step by step carefully.
How I can config correctly?
I´m using VM 12.0.2.
Regards.
Telles.
Solved! Go to Solution.
Your screen shot shows an old version of ThingWorx. The guides are updated to use the latest version of ThingWorx which is available both as a download or a PTC Cloud hosted trial:
https://developer.thingworx.com/en/resources/trials
Your screen shot shows an old version of ThingWorx. The guides are updated to use the latest version of ThingWorx which is available both as a download or a PTC Cloud hosted trial:
https://developer.thingworx.com/en/resources/trials
Hi, Rick!
I download the lastest version of a VM (12.0.2.0 Rev1) int PTC data base:
https://extranet.ptc.com/sites/TDD/SitePages/VMDownloadInfo.aspx
And in the documentation is mentioned this version for TW ir 9.2:
Tks for helping.
Rafael Telles.
Hi @Telles
It sounds like you've resolved your issue. If so, please mark the appropriate response as the Accepted Solution for the benefit of others with the same issue.
Regards.
--Sharon
Hi, Sharon.
I´m not resolved the problema. This project has stop until I communicate my devices with TX, but the trainning than I don´t found it.
Hi!
This VM is avaible in PTC platform for custumers.
Regards.
Telles.
I keep going with studeis using the nem VM lanched last mouth