Skip to main content
O
opavot1-Visitor
1-Visitor
October 5, 2010
Question

Circular symetry constraint problem

  • October 5, 2010
  • 1 reply
  • 2564 views

Dear all

I have creat a simulation on Wildfire 4 using a circular symetry constraint to save time

When I look the results , I see that the piston is turning arround the axis , for me this is not correct because with circulare symetry constraint the parts a lock in rotation

I you have an idea about my mistake it will be great

Best regards

Olivier


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

O
opavot1-VisitorAuthor
1-Visitor
October 7, 2010

Dear All

it seems I have to use a cylindrical coordinate system when I work with a circular symetry constraint

I check in the PTC help center , but I don't find anything to confirme it

Do you have any information confirm this ?

Best regards

OP

J
JonathanHodgson13-Aquamarine
13-Aquamarine
November 3, 2010

Hi Olivier,

I don't think that a rotational symmetry constraint prevents rotation.

It simply constrains nodes on each surface to rotate by the same amount. Otherwise, it would overconstrain the part and prevent it from deforming in some directions.

Like you say, you can use a cylindrical coordinate system to apply rotation constraints (lock Theta direction). Or you could constrain a point on your model from moving in a direction normal to one of the symmetry planes - you could do this in Cartesian coordinates too.

Terms & ConditionsCookie settingsAccessibility statement