Question
Ecad thick dxf
Ecad Interfacers:
We asked our Mentor ECAD people to create lines (sort of keep out) as
zones (they will be RF walls) in their data and transfer as DXF to us to
Pro/E WF5. Normally we do the opposite with keep outs. The lines come in
thick. I assume polylines? Anyway to have them come in normal?
Years ago I used AutoCad as an in between to explode the polylines in
PADS data, then export out again as dxf. This came into Pro/e fine. We'd
prefer to not have this or any other in go between step if possible.
Thanks,
WayneF
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
We asked our Mentor ECAD people to create lines (sort of keep out) as
zones (they will be RF walls) in their data and transfer as DXF to us to
Pro/E WF5. Normally we do the opposite with keep outs. The lines come in
thick. I assume polylines? Anyway to have them come in normal?
Years ago I used AutoCad as an in between to explode the polylines in
PADS data, then export out again as dxf. This came into Pro/e fine. We'd
prefer to not have this or any other in go between step if possible.
Thanks,
WayneF
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.