Skip to main content
S
sshannon1-Visitor
1-Visitor
December 7, 2011
Question

GD&T w/ dual dim's -how to change decimal places?

  • December 7, 2011
  • 2 replies
  • 1278 views

I have a print that is dual dimensioned. (mm primary -inch secondary w/ the display set to secondary[primary])

 

The problem I'm having is in the geomentric tolerances. The value is shown as .0 [0.02].

 

Anybody know how to change the decimal places of the secondary to show as .001 [0.02]?

 

 

 

Regards,

 

Steve Shannon

 

Tooling Engineer

 

matic

 

300 East 48th St.

 

Holland, MI 49423

 

phone (616) 820-2427

 

fax(616) 820-2488

 

www.transmatic.com

 

mailto:-

 


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

2 replies

D
DeanLong1-Visitor
1-Visitor
December 7, 2011

Should be a combo solution in your drawing setup file.


Dual_digits_diff


lead_trail_zeros


Your feature control frame values will follow the dim decimal places and zeros configuration.

D
DeanLong1-Visitor
1-Visitor
December 7, 2011

Oh....make sure your lead_trail_zeros_scope is set to "all". It should be as it is the default value. Check it regardless.

In Reply to Dean Long:



Should be a combo solution in your drawing setup file.


Dual_digits_diff


lead_trail_zeros


Your feature control frame values will follow the dim decimal places and zeros configuration.


Terms & ConditionsAccessibility statement