Question
RES: line weight in drawings
- January 6, 2010
- 0 replies
- 664 views
Hi,
In order to use the same pen sizes both the plot and the pdf creation, you
must use these two parameters:
pdf_use_pentable yes
pen_table_file use_8_plotter_pens yes
logo PLMGuilherme Rocha
Consultor/Suporte Técnico PRO/E
PLM Solutions do Brasil
O representante estratégico da PTC
Tel.: (55-11) 5052-9730 R. 205
Tool Free: 0800-701-9730
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
In order to use the same pen sizes both the plot and the pdf creation, you
must use these two parameters:
pdf_use_pentable yes
pen_table_file use_8_plotter_pens yes
logo PLMGuilherme Rocha
Consultor/Suporte Técnico PRO/E
PLM Solutions do Brasil
O representante estratégico da PTC
Tel.: (55-11) 5052-9730 R. 205
Tool Free: 0800-701-9730
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.