cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Creo 3.0 3D Annotation

sfalconer
1-Newbie

Creo 3.0 3D Annotation

When I move a shown dimension to a new plane in a 3D model (not a drawing) it creates little dashed offset lines. I have tried picking the lines, moving the lines to a new layer then turning off that layer. So far, I can't do anything to make these lines go away! Please HELP!!

dwg_1.jpg

dwg_2.jpg

4 REPLIES 4

Scott,

Set config option display_z_extension_lines as no to control the display.

Those extension lines have been such a blight on my model views, and this config setting is the perfect remediation!  Thank you so much!

MaheshSh,

 

What else does that setting affect if I turn it to no ?

 

Mahesh_Sharma
22-Sapphire I
(To:llie)

Top Tags