Skip to main content
Dale_Rosema
23-Emerald III
Dale_Rosema23-Emerald III
23-Emerald III
January 27, 2015
Solved

Family Table of Charted Dimensioin in an Assembly Drawing

  • January 27, 2015
  • 2 replies
  • 5576 views

I recently asked some questions about charted dimensions on a family table for a part drawing.

http://communities.ptc.com/message/254543#254543

Now I am trying to do something similar with an assembly, but I would like to have instance, P/N (parameter), WIP P/N (parameter), RAW P/N (parameter in the one part that is in the assemly that is machined), DIM "A" & DIM "B" (driven dimensions) and DIM "C" (driven dimension / parameter).

I was trying to start by just modifying the table I had from the previous model and change the filter for the Length to the "C", but the table will not propagate with these three - instance/pn/"C".

Thanks,

Dale


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Best answer by Dale_Rosema

I ended up using a charted drawing with individual repeat regions and filters for each repeat region similar to this thread:

http://support.ptc.com/cs/cs_26/howto/dwt_no2d/dwt_no2d.htm

Thanks, Dale

2 replies

Dale_Rosema
23-Emerald III
Dale_Rosema23-Emerald IIIAuthor
23-Emerald III
January 27, 2015

Now I am getting an error message that "some drawing tables were frozen; these are not updated."

Dale_Rosema
23-Emerald III
Dale_Rosema23-Emerald IIIAuthor
23-Emerald III
January 27, 2015

I started a new table similar to the one I created for the individual part. I have the instance, pn, wip pn, and dim "C" working.

I am trying to get the RAW PN (part number from the only part in the assembly. It is an assembly because other work is being done to the raw part), QTY, DIM "A" & "B" driven dimension that are not parameters to work.

When I created a filter with "B" (driven measured dimension) similar to "C" (a parameter) the column just shows up blank.

Dim "A" is the overall length that, if I could, I could pull from the a parameter from the raw part.

Any thoughts.

Thanks, Dale

Dale_Rosema
23-Emerald III
Dale_Rosema23-Emerald IIIAuthor
23-Emerald III
January 27, 2015

I was trying to use the parameter name from the componenet (length). Tom Uminn Do you know if this is possible?

Thanks, Dale

Dale_Rosema
23-Emerald III
Dale_Rosema23-Emerald IIIAuthorAnswer
23-Emerald III
March 18, 2015

I ended up using a charted drawing with individual repeat regions and filters for each repeat region similar to this thread:

http://support.ptc.com/cs/cs_26/howto/dwt_no2d/dwt_no2d.htm

Thanks, Dale

Terms & ConditionsAccessibility statement