Question
ball mechanism with constraints??
Hi all,
is there any way to model a ball mechanism with constraints? How to you
constrain the moving part to move inside a cone of 12 degrees ? (for
example)
of course the tip of the cone must be the datum point used of the ball
mechanism.
thanks in advance
--
---------------------------
-nk/.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
is there any way to model a ball mechanism with constraints? How to you
constrain the moving part to move inside a cone of 12 degrees ? (for
example)
of course the tip of the cone must be the datum point used of the ball
mechanism.
thanks in advance
--
---------------------------
-nk/.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.