Skip to main content
rohit_rajan15-Moonstone
15-Moonstone
October 1, 2013
Question

can i show to different half section in one drawing view

  • October 1, 2013
  • 2 replies
  • 1221 views

old drawings showed to different half sections in one view. can this be done on Pro/E?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

2 replies

TomD.inPDX17-Peridot
17-Peridot
October 1, 2013

That sounds like an offset section.

ptc-50080821-Visitor
1-Visitor
October 2, 2013

You can have multiple sections displayed on one view.

It has to be a LOCAL cross section rather than a HALF section.

With a half section you can select a datum plane and section to one side only - but there can only be one of those per view.

With the local section you have to sketch a spline (akin to a partial view) but it is then difficult to get a dead straight line, also the boundaries of multiple sections cannot overlap so you have to persevere to get it to look smart!

Terms & ConditionsAccessibility statement