Skip to main content
M
mconley1-Visitor
1-Visitor
May 22, 2017
Solved

can not modify drawing cross hatch creo 3.0

  • May 22, 2017
  • 3 replies
  • 8094 views

I have tried everything; there no way to select the drawing xhatch and change spacing or angles. I have looked up all the online answers and my GUI doesn't not have a modify xhatch.

Please help

Best answer by AmitDeshpande

Hi Michael,

When you are in the Layout tab of the drawing, you should be able to hover over and highlight the xhatch.  Then after selecting it, Properties should be available in the RMB menu, which should open the MOD XHATCH menu manager.

Please upload your files to the thread, so we can take a look at the issue.

Thanks,

Amit

3 replies

A
AmitDeshpande18-OpalAnswer
18-Opal
May 22, 2017

Hi Michael,

When you are in the Layout tab of the drawing, you should be able to hover over and highlight the xhatch.  Then after selecting it, Properties should be available in the RMB menu, which should open the MOD XHATCH menu manager.

Please upload your files to the thread, so we can take a look at the issue.

Thanks,

Amit

    M
    mconley1-VisitorAuthor
    1-Visitor
    May 24, 2017

    Thanks, I was not in Layout mode I was in Annotate mode; I did find it in legacy migration mode; but after looking around finally found it.

    thank

      A
      AmitDeshpande18-Opal
      18-Opal
      May 25, 2017

      Hi Michael,

      Glad that worked.  Would you mind marking it as the Correct Answer, so any other user, looking for a similar solution, can find it easily.

      Thanks,

      Amit

        Terms & ConditionsAccessibility statement