Question
Control offset cross section display
WF4
Is there any way to control the side of an offset (sketched) cross
section that is removed? I know I can go in and 'flip' it to show the
other side, but I'm dealing with a moderately large assembly and it
takes a long time to display the section, and then the same long time to
display it again when flipped. I always want it displayed the other
way, but I've there doesn't seem to be a way to control it, at least on
an offset section.
Thanks,
Doug Schaefer
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Is there any way to control the side of an offset (sketched) cross
section that is removed? I know I can go in and 'flip' it to show the
other side, but I'm dealing with a moderately large assembly and it
takes a long time to display the section, and then the same long time to
display it again when flipped. I always want it displayed the other
way, but I've there doesn't seem to be a way to control it, at least on
an offset section.
Thanks,
Doug Schaefer
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.