Skip to main content
ptc-46297791-Visitor
1-Visitor
July 18, 2013
Question

Creo Motion

  • July 18, 2013
  • 1 reply
  • 1033 views

Dear friends,

I am using Creo 2.0, How to create machanism connections that enable motion components in an assembly.

Please advice me.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

TomD.inPDX17-Peridot
17-Peridot
July 18, 2013

This is a big question. Please provide what you have already learned.

Mechanisms are highly dependent on assembly constraints. You create gear connections and servo motors. You run an analysis of the "profile" and you can play the results.

There are some very good tutorials on the PTC knowledge base website.

Terms & ConditionsAccessibility statement