Skip to main content
A
Anonymous
February 8, 2010
Question

Display of required components in a assembly view in draftin

  • February 8, 2010
  • 1 reply
  • 1334 views
Hi, Can any one tell me how to control the display of interested component display in a assembly view in drafting.I mean to show component 2 and 3 without showing the other components in an assembly of 5 components. Or If possible could i show the unwanted component in a assembly view in dotted lines so that i can specify the component of interest. Regards vishal
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

C
cfitzgerald-21-Visitor
1-Visitor
February 8, 2010
Hi Vishal, Recommend creating a simplified rep in the assembly. Exclude the top level and set the components you want shown as Master Rep. Return to the drawing and set the view properties to the simplified rep. or In drawing mode select View>Drawing Display>Component Display. This should allow you to blank components or set components as phantom lines. Regards-
A
Anonymous
February 9, 2010
Thank you very much
Terms & ConditionsAccessibility statement