Skip to main content
aminhas14-Alexandrite
14-Alexandrite
October 17, 2014
Question

how to convert iges file in to part file creo?

  • October 17, 2014
  • 1 reply
  • 2414 views

Hello everyone,

any buddy guide me how to make drawing attached file part in Creo 3?

kind regards,

Adnan


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

dwinrich1-Visitor
1-Visitor
October 17, 2014

Hi Adnan,

Open the iges file in Creo and save as a new file. *NOTE, when opening, you will need to change the TYPE to All in the open box to see the required file. Then create a drawing, if you use the same file name, it will pull the part into the drawing automatically. Add views to the drawing as you would anything.

Hope that helps.

Terms & ConditionsAccessibility statement