Skip to main content
W
wbeattie1-Visitor
1-Visitor
July 23, 2016
Question

Multiple bends on a sheet metal bracket

  • July 23, 2016
  • 2 replies
  • 2424 views

Hi all,

        I new to Creo and have been watching a lot of videos on YouTube but i have a problem I've not found the answer to.

I need to make the bracket (attached below) but the bracket itself bend to the right slightly and the wall of the bracket is at 90 degree bend decreasing to 80 at the front.

If anyone could help me make this i would really appreciate it.

Thank You

Bill


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

2 replies

M
manjunathrv17-Peridot
17-Peridot
July 25, 2016

I would first create a solid model and then convert to sheetmetal. See attached prt.

Note that the model is only representative of your drawing and not as per the dimensions mentioned.

B
BenLoosli23-Emerald III
23-Emerald III
July 25, 2016

Creo is not designed to make a changing angle bend. The solid model of your shape then convert to sheet metal is the best way to make a shape that cannot be modeled in the sheet metal package.

Terms & ConditionsAccessibility statement