Question
Pro/PIPING - How to recover insulation end points coordinates in a drawing ?
Hello all,
I cannot figure out how to recover end points coordinates of an insulation created in Pro/PIPIG (Pro/E WF2)in a drawing.
I only get an information window, but don't see any related parameter I could recover in a table, as it is possible for tubes.
Many thanks advanced.
Kind regards.
Jean-Michel.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.