1-Visitor
Jul 28, 2010 7:35 PM UTC
Question
Volume
- 2 replies
- 1720 views
- Translate All
hello,
i'm trying to rough using volume, but the tool is invading (within green square in picture attached)
the only way i know is to change the model but i don't want to do that because i will have a few problems, i would like to know if anybody knows another way for the nc sequence recognize a surface or anything else as part.
i'm trying to rough using volume, but the tool is invading (within green square in picture attached)
the only way i know is to change the model but i don't want to do that because i will have a few problems, i would like to know if anybody knows another way for the nc sequence recognize a surface or anything else as part.

