We are getting an efx error when starting creo 4.0 release m010. Any fixes for this?

Forum|Forum|9 years ago
May 1, 2017
4 replies
5197 views

As stated above we have an older computer in our office, currently when we open Creo 4.0 on that computer we get an error while opening stating efx failed to load. Not sure what this affects but is there a remedy for this? Thank you in advance.

Assembly Design

G

gspencer

1-Visitor

Nathan,

This is documented issue for M010 (Ref: CS260229) There is currently SPR 6604568 filed, with a fix in Creo Parametric 4.0 M020

Hope this helps...

D

davehaigh

13-Aquamarine

Just saw this error yesterday and looked it up on PTC support page today. I'm a bit concerned what letting this obvious error be released says for PTC's Quality Control for Creo 4.