Skip to main content
R
Ruben11-Visitor
1-Visitor
May 7, 2020
Question

Calculating DRAG

  • May 7, 2020
  • 1 reply
  • 1752 views

Hello everyone,

I'm designing a car and would like to calculate drag with flow analysis.

Is this possible and is there a tutorial that I can follow? 

1 reply

B
bafoster841-Visitor
1-Visitor
May 13, 2020

I think flow analysis is possible in Creo 5.0 and some later builds of 4.0. I am not sure about earlier versions. I should also note that it seemed the flow analysis application was independent of Creo Simulate. I know there is a tutorial in PTC's LMS website (precisionlms.ptc.com), but you have to have a subscription.

R
Ruben11-VisitorAuthor
1-Visitor
May 13, 2020

I already have flow analysis, I just want to know if it's possible to calculate drag and how to do it... it would really help me a lot... 

 

 

Terms & ConditionsAccessibility statement