Skip to main content
S
Sam_928-Gravel
8-Gravel
September 29, 2025
Question

Finding Stresses on the Parts while twisting

  • September 29, 2025
  • 2 replies
  • 327 views

Hi,

 

I’ve been trying to identify the stress distribution while twisting happens through simulation but haven’t been able to get accurate results so far. Could someone please assist with setting up or running the analysis?

 

FYI: all parts are plastics(PP), motor will be 10 nm, the blue highlighted area are screws, and the red highlighted area is load acting.

Let me know if you need any. 

2 replies

S
skunks19-Tanzanite
19-Tanzanite
September 30, 2025

Creo models are not FEM models;
FEM models must be created separately, which is a laborious process 😂

 

cf. https://community.ptc.com/t5/Analysis/Tutorial-Creo-Simulate-Elite/td-p/1010518

PDF, page 3

A
anursinghCommunity Manager
Community Manager
October 22, 2025

Hi @Sam_92,

 

I wanted to see if you got the help you needed.

If so, please mark the appropriate reply as the Accepted Solution. It will help other members who may have the same question.
Of course, if you have more to share on your issue, please pursue the conversation. 

 

Thanks,
Anurag 

Terms & ConditionsCookie settingsAccessibility statement