Skip to main content
B
Breslerek1-Visitor
1-Visitor
March 17, 2019
Question

Prcoess Guide in Creo Simulate

  • March 17, 2019
  • 1 reply
  • 1853 views

Hi everyone, 

 

I am currently using Creo 5 (educational version) for a project at my university. I am trying to prepare a part (adding profiles and material parameters)  to run a structural analysis on university computer, where I have access to academic version. In Creo 4 I could easily access "Simulate", but whenever I open it in Creo 5 I am presented with "Process Guide" window. I tried to switch it off by changing simulation_process_prompt to "no*",  but it didn't help.

 

Is there any way to get rid of this feature?

I would be very grateful for help in resolving this problem. 

1 reply

T
tshen17-Peridot
17-Peridot
April 18, 2019

I think you may not get the standalone license for Creo Simulate. 

Currently you just use the free version Creo Simulate Lite.

For Creo Simulate Lite, you have to use Process Guide mode and cannot disable it.

If you want to know more about Creo Simulate Lite, please refer to https://www.ptc.com/en/support/article?n=CS99824

 

    Terms & ConditionsAccessibility statement