Skip to main content
T
tangerine1-Visitor
1-Visitor
September 30, 2004
Question

Auto Zoom... still

  • September 30, 2004
  • 2 replies
  • 731 views
Two suggestions gratefully recieved, but neither worked.. - I think the
model zooms out and seems to centre about the global - (even if there is
nothing there !!)

Neither of these do the job.. ! :-((
MAX_ANIMATION_TIME 0
sketcher_refit_after_dim_modify

Any other ideas ??

    2 replies

    U
    unknown11-Visitor
    1-Visitor
    September 30, 2004
    I think the rmb should release the auto zoom. I didn't see the other
    responses to know if I'm being redundant. if that doesn't work then some
    steaming coffee poured onto the keyboard will certainly stop things.
    P
    ptc-1532191-Visitor
    1-Visitor
    September 30, 2004
    This is a complaint I've had for years. The model re-orients during certain
    operations (redefine being good one).

    PTC acknowledge the issue and filed an SPR on it (#1031717). As far as I
    can tell it was not fixed in 2001 or WF. Don't know about WF 2, but the SPR
    is still open.

    Dave
    Terms & ConditionsAccessibility statement