Skip to main content
N
nrollins2-Explorer
2-Explorer
February 12, 2014
Question

automatic regen - Creo2

  • February 12, 2014
  • 1 reply
  • 640 views
Hello again.



I seem to get a message almost every time I save that says "model XXX is not
regenerated"



As a rule, I would like to save my models fully regenerated. I don't ever
remember seeing this message before moving to Creo2. Is there a setting
that controls automatic regen? Is this message linked to some new
functionality in Creo2?



Its No Big Deal to regen and then save, but I'd like to understand what is
going on. Does anyone know? If necessary, I will make a mapkey to regen
and then save. but I think there is something at play here and I want to
know what.



Thanks a lot! (again)



-Nate

    1 reply

    N
    nrollins2-ExplorerAuthor
    2-Explorer
    February 14, 2014
    There's a config setting



    mass_property_calculate



    If it is set to "automatic", the model looks for a regen and shows a yellow
    traffic light.



    There's an SPR : 2138055



    Change the setting from "auto" to "by_request" is the PTC sanctioned
    workaround.



    Thanks to Todd!



    -Nate


    Terms & ConditionsAccessibility statement