Skip to main content
T
TrainStopper12-Amethyst
12-Amethyst
February 1, 2010
Question

Bend Allowance for SS

  • February 1, 2010
  • 1 reply
  • 675 views
Hi Folks,



Just asking if anybody would be willing to share their thoughts on bend
details for 316L Annealed SS?

We are going to be air bending 10 gauge (.135) with 3/4" V dies, this
combination is a bit off the charts so I'm anticipating it might not
conform to one of the standard bend tables.



BTW, which bend table would normally be used for 316L SS?



Thanks!



Regards,

Walt Weiss





    1 reply

    M
    mjenkins10-Marble
    10-Marble
    February 1, 2010
    I don't know if this helps but I havesome min bend radiifor 302 on my old TAD slide rule:

    Michael R. Jenkins P.E.
    Design Engineer
    Direct: 816-801-2332
    Fax: 816-891-9432

    Commercial Vehicle Systems
    Haldex Brake Products Corporation
    10930 North Pomona Avenue
    Kansas City, MO 64153-1215
    Terms & ConditionsCookie settingsAccessibility statement