Skip to main content
ptc-10091241-Visitor
1-Visitor
Mar 3, 2008 8:38 PM UTC
Question

Fast highlight in WF3.0?

When I attended the PTC Users Conference 2006 in Dallas, TX, I remember in one of the seminars the instructor covered a command called Fast Highlight. This command controls what happens to your model geometry when you drag your mouse across the screen. Has anyone else heard of this command in ProE/Wildfire 3.0 and how to turn it on or off? Thanks, Mike

    3 replies

    MarkMcDonald12-Amethyst
    12-Amethyst
    Mar 4, 2008 2:27 PM UTC
    It is a config.pro option, fast_highlight with values of yes or no.
    Translate
    BertelJensen1-Visitor
    1-Visitor
    Mar 4, 2008 2:35 PM UTC

    "Mike Ellis" wrote:

    When I attended the PTC Users Conference 2006 in Dallas, TX, I remember in one of the seminars the instructor covered a command called Fast Highlight. This command controls what happens to your model geometry when you drag your mouse across the screen. Has anyone else heard of this command in ProE/Wildfire 3.0 and how to turn it on or off? Thanks, Mike

    Translate
    ptc-10091241-VisitorAuthor
    1-Visitor
    Mar 4, 2008 3:00 PM UTC
    Thank you Bertel. I found out how to change it not too much longer after I posted my original message. I also was wondering why there was a long delay when switching between shaded and wireframe views, and now I know why. Mike
    Translate
    Terms & ConditionsAccessibility statement