Skip to main content
C
cdown1-Visitor
1-Visitor
November 21, 2005
Question

Geometrical Tolerances

  • November 21, 2005
  • 2 replies
  • 1030 views
All, I am trying to write a geom tol into a table cell, I seam to remeber
you can do this but I can't seam to find out how, can anyone point me it the
right direction?

Or tell me how to do it?

Many thanks

Colin Down
mechanical designer
Motorola

    2 replies

    A
    agaribay1-Visitor
    1-Visitor
    September 2, 2010
    I know there's a way, but it's been awhile.



    In Drawing Mode, how do you attach a Geometric Tolerance to a Created
    Dimension (addXX as opposed to a shown dimension dXX).



    I thought there was a setting??







    Thank you.



    WF2.0



    -Art








    .

    .

    .

    .

    This message (including any attachments) contains

    confidential and/or proprietary information intended

    only for the addressee. Any unauthorized disclosure,

    copying, distribution or reliance on the contents of this

    information is strictly prohibited and may constitute a violation

    of law. If you are not the intended recipient, please notify the

    sender immediately by responding to this e-mail, and delete the

    message from your system. If you have any questions about this

    e-mail please notify the sender immediately.
    B
    bfrandsen10-Marble
    10-Marble
    September 3, 2010
    Art,
    To mix shown GTOL with created dimension or vica versa you have to set the
    config option: create_drawing_dims_only NO. This will store the created
    dimension in the 3D model as well and allow what you want.
    Here we normally do not store created dimension in the model, as we want
    different persons to work and the drawing and model simultaniously.
    But when the draftsmen is going to create a dimension that will be
    referenced by a shown GTOL, they toggle this config option while creating
    it after ensuring they can take ownership of the 3D model in that short
    period of time.

    Regards,
    Bjarne



    Art Garibay <->
    02-09-2010 21:53
    Please respond to
    Art Garibay <->


    To
    -
    cc

    Subject
    [proecad] - Geometric Tolerances






    I know there’s a way, but it’s been awhile.

    In Drawing Mode, how do you attach a Geometric Tolerance to a Created
    Dimension (addXX as opposed to a shown dimension dXX).

    I thought there was a setting??



    Thank you.

    WF2.0

    -Art



    . . . . This message (including any attachments) contains confidential
    and/or proprietary information intended only for the addressee. Any
    unauthorized disclosure, copying, distribution or reliance on the contents
    of this information is strictly prohibited and may constitute a violation
    of law. If you are not the intended recipient, please notify the sender
    immediately by responding to this e-mail, and delete the message from your
    system. If you have any questions about this e-mail please notify the
    sender immediately.
    Attachment Links: image002.jpg (11 k) Site Links: View post online View
    mailing list online Send new post via email Unsubscribe from this
    mailing list Manage your subscription Use of this email content is
    governed by the terms of service at:
    Terms & ConditionsAccessibility statement