Question
[proecad] - Backward Compatability between Wildfire 4.0 and 3.0???
As Chris said, there's a patch at ptc.com that can be applied to WF3 &
WF2 to allow you to open newer models.
As far as the releases being close together, I find that there's a
relative eternity between releases these days. When I started with
release 18, a new version came out every 6 months. Now it's about
triple that. Frankly, keeping up with them coming that fast would be
challenging, but the change from version to version was smaller too.
Doug Schaefer
WF2 to allow you to open newer models.
As far as the releases being close together, I find that there's a
relative eternity between releases these days. When I started with
release 18, a new version came out every 6 months. Now it's about
triple that. Frankly, keeping up with them coming that fast would be
challenging, but the change from version to version was smaller too.
Doug Schaefer