Skip to main content
unknown11-Visitor
1-Visitor
Jul 1, 2004 6:26 PM UTC
Question

tapered to point

Hi Group,

I need to model a round needle that is bent, but also tapers down to a
point. Can anyone give me some pointers on how to do this??

Any help is highly appreciated

Christine

    3 replies

    unknown11-VisitorAuthor
    1-Visitor
    Jul 1, 2004 6:51 PM UTC
    Variable section sweeps, swept blends, blends

    Do you have a pic?

    --
    Rui



    "Christine Bickenbach" <-> wrote in message
    news:51758@model...
    >
    > Hi Group,
    >
    > I need to model a round needle that is bent, but also tapers down to a
    > point. Can anyone give me some pointers on how to do this??
    >
    > Any help is highly appreciated
    >
    > Christine
    >
    >
    Translate
    unknown11-VisitorAuthor
    1-Visitor
    Jul 1, 2004 6:57 PM UTC
    Rui, don't you think the the Needle Point should be a revolved conic?


    Ron Davis, Sr Mech Product Designer
    Rackable Systems, Inc
    San Jose, Ca. 95131

    (510) 290-4567

    Translate
    unknown11-VisitorAuthor
    1-Visitor
    Jul 1, 2004 10:06 PM UTC
    Not if it's bent as Christine says.

    --
    Rui



    "Ron Davis" <rdavis@rackable.com> wrote in message news:51767@model...


    Rui, don't you think the the Needle Point should be a revolved conic?


    Ron Davis, Sr Mech Product Designer
    Rackable Systems, Inc
    San Jose, Ca. 95131

    (510) 290-4567

    Translate
    Terms & ConditionsAccessibility statement