Skip to main content
frank.puerta1-Visitor
1-Visitor
Sep 26, 2008 6:49 PM UTC
Question

Zooming with the mouse wheel in Pro/e

Does anyone knows how to change the zoom factor in Pro/Engineer so that I can control how fast to zoom in and out when rotating the mouse wheel?

Thanks.

    4 replies

    pfadams1-Visitor
    1-Visitor
    Sep 26, 2008 6:55 PM UTC
    Frank
    It is Friday and it was a long week so here it
    goes....................move the wheel sloooower

    Sorry couldn't resist
    Translate
    vmcdaniel1-Visitor
    1-Visitor
    Sep 26, 2008 7:01 PM UTC
    You can use CTRL and SHIFT to 1/2 or 2x the zoom

    Vaughn McDaniel III




    "Frank Puerta" <->
    09/26/2008 12:49 PM
    Please respond to
    "Frank Puerta" <->


    To
    -
    cc

    Subject
    [proecad] - Zooming with the mouse wheel in Pro/e






    Does anyone knows how to change the zoom factor in Pro/Engineer so that I
    can control how fast to zoom in and out when rotating the mouse wheel?
    Thanks.
    ----------
    Translate
    frank.puerta1-VisitorAuthor
    1-Visitor
    Sep 26, 2008 7:03 PM UTC
    Well, at least you made us all laugh here, good weekend.


    Translate
    ptc-6808411-Visitor
    1-Visitor
    Sep 26, 2008 7:15 PM UTC
    Frank, Out of the box, there are two "wheel mouse zoom settings" you can use: - Fine Zoom: This is what you get when you roll the wheel. We are all using this.- Coarse Zoom: Hold the CRTL key and roll the wheel. You will zoom in closer or zoom out farther with the same wheel motion. Many people may not be aware of this one ... Sorry I could not find a setting to further control this ... I am just a ProductView guy. Regards, Andy B.www.productview.com- ProductViewBasic Training $89, Advanced $99 These are the PTC terms for this, not mine.
    Translate
    Terms & ConditionsAccessibility statement