Skip to main content
RyanL.Butcher14-Alexandrite
14-Alexandrite
February 1, 2023

Creo Parametric Progressive Die Tips and Techniques

  • April 14, 2026 at 7:41 PM
  • 2 replies
  • 7875 views
  • Translate All

Check out this video on Creo Parametric Progressive Die Tips and Techniques session  from PTC Application Engineers.

Presenters: Lee Goodwin (Solution Consulting, Principle) and Ryan Butcher (Solution Consulting, Fellow).

 

Creo Progressive Die Learning

 

 

2 replies

Dayna_M14-Alexandrite
14-Alexandrite
February 6, 2023

WEBCAST Q&A

 

Question from Mark:  In terms of designing a part, how is PDX different from Creo Sheetmetal?  I've used Sheetmetal but when would i need to use PDX?

Answer:  Sheetmetal is the design phase in the process.  PDX is for developing/designing the tooling for the manufacturing process.

Question from Mark:  Thank you for the last question.  Similar to PDX, is there a tool for injection molding die design?

Answer:  Yes, Expert Moldbase (EMX).

Translate
Dayna_M14-Alexandrite
14-Alexandrite
February 6, 2023

WEBCAST Q&A

 

Question from Sandeep:  Does one need a separate license for adding the PDX plug-in, inside the already existing Creo toolbar?

Answer:  Yes, it is an add-on extension.

Translate
Terms & ConditionsAccessibility statement