14-Alexandrite

Plastic Part Design Tips & Techniques Session Recording (West Coast)

Check out this video on Creo Plastic Part Design from PTC Application Engineers

Presenters: Lino Tozzi (Technical Specialist, Fellow) and Ryan Butcher (Technical Specialist, Fellow)

Original Date Presented: November 9, 2021

To dive deeper into the subject, check out Rounds, Ribs, Draft.

14-Alexandrite

Webcast Q&A

Question from Chris: Are these techniques also preferred for non-plastic parts?

Answer: Yes, it builds intent intelligence into your design for forthcoming changes.

14-Alexandrite

Webcast Q&A

Question from John: Do you have a recommended order of feature addition (like bodies, chamfers, drafts, then rounds for eg)?

Answer: Creation order of those features is not critical any more, based on the auto handling of those features when changes occur.

14-Alexandrite

Webcast Q&A

Question from Marvin: Are trajectory ribs only available between surfaces, or can the ribs be free standing?

Answer: Only between surfaces.

Sign up