Skip to main content
R
RyanL.Butcher14-Alexandrite
14-Alexandrite
September 20, 2021

Tool Design/Mold Analysis Tips & Techniques Session Recording (West Coast)

  • September 20, 2021
  • 1 reply
  • 1242 views

Check out this video on Tool Design/Mold Analysis from PTC Application Engineers

Presenters: Lee Goodwin (Technical Specialist, Principal) and Lino Tozzi (Technical Specialist, Fellow)

Original Date Presented: September 14, 2021


To dive deeper into the subject, check out PTC University.

 

    1 reply

    D
    Dayna_M14-Alexandrite
    14-Alexandrite
    September 21, 2021

    Webcast Q&A

    Question from Jon:  I'm a member of ASME Y14.8 Castings, Forgings and Moldings.  Would you have any recommendations pertaining to the standard:  good or bad symbols?  Useful concepts such as datum targets?  Short comings to be addressed?

    Answer:  I am assuming this is for detailing purposes.  At this moment we support up to ASME Y14.5.

     

    Terms & ConditionsCookie settingsAccessibility statement