Skip to main content
B
BenLoosli23-Emerald III
23-Emerald III
June 23, 2014
Question

Creo2 M100 install

  • June 23, 2014
  • 1 reply
  • 708 views

I just tried to install Creo2 M100 to x:\ptc and it went to the default
c:\Program Files\PTC folder instead. I even did it twice to be sure I had it
enetered properly. Has anyome else seen this behavior?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

B
BenLoosli23-Emerald IIIAuthor
23-Emerald III
June 23, 2014
The ENTER key was the trick to get the non-default directory to take.

Thanks to all.

BTW - I entered this question in the PTC Community first, then the exploder. Got 4 answers from the exploder and the question has not even showed up in email from the PTC Community yet. I did make sure I have email on the community enabled and I have received Creo emails this morning.

Terms & ConditionsAccessibility statement