Skip to main content
17-Peridot
November 12, 2010
Question

Questions, comments,concerns or even complaints?

  • November 12, 2010
  • 3 replies
  • 4803 views

If you have questions, comments, concerns or even complaints, post it here!

Here is a list of our products:

Main Products

Knowledge Based Engineering

SmartApps

    3 replies

    1-Visitor
    January 26, 2016

    Hi,

    I need to Know how to add standard die base library in PDX instead of editing individual plates. Is it possible?

    13-Aquamarine
    January 28, 2016

    Hi Rajesh,

    there are two ways to prepare die sets:

    - Create your standard die set once in the plate wizard and use File > Save. You can later on retrieve this setup by File > Open. This information is usually stored in <PDX>\configuration\my_plates.

    or

    - Create the Creo data of your die set and save it to <PDX>\configuration\my_diesets. You can use these templates later on when creating a new project in PDX.

    In PDX 9.0 you have also the possibility to save die sets to in sub directories of <PDX>\components\<unit>\plate and retrieve these in the plate wizard by selecting supplier and size.

    Regards,

      Achim

    1-Visitor
    January 28, 2016

    Hi Achim

    Thanks for your Reply..

    I want to know how integrate form analysis to PDX, and where I can download that tool.

    Thanks & Regards,

    Rajesh D

    1-Visitor
    January 29, 2016

    Hi Achim,

    I am asking about BEA (Blank Estimation Analysis) integration in PDX.

    I want to know in EMX how to edit slider angle pin dia and also I want to add misumi sliders. Do you offer any std Misumi Sliders

    Regards,

    Rajesh D

    1-Visitor
    February 2, 2016

    Hi,

    Is it possible to give space between core plate and cavity plate in EMX, If possible let me know the procedure.

    Regards,

    Rajesh D