1-Visitor
March 8, 2010
Question
Tool Path
- March 8, 2010
- 1 reply
- 941 views
In Wildfire4 I use a volume mill with a mill window. When I run the tool
path it shows the path taken with a red line from the center of the
tool. When I try to move the part to see where the path has been the
lines disappear. How do I keep these lines visible so I can see where
the path is.
<<presentation1.ppt>>
Thanks,
Byron Taylor
Coordinator/Programmer
Danfoss commercial Compressors
One Scroll Drive
Arkadelphia, AR 71923
E-mail: byron.taylor@scrolltech.com
Tel.:870-246-0750
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
path it shows the path taken with a red line from the center of the
tool. When I try to move the part to see where the path has been the
lines disappear. How do I keep these lines visible so I can see where
the path is.
<<presentation1.ppt>>
Thanks,
Byron Taylor
Coordinator/Programmer
Danfoss commercial Compressors
One Scroll Drive
Arkadelphia, AR 71923
E-mail: byron.taylor@scrolltech.com
Tel.:870-246-0750
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.