Skip to main content
E
eliu14-Alexandrite
14-Alexandrite
May 28, 2019
Question

Creo View: Multi-byte characters are not supported for NX PMI conversion

  • May 28, 2019
  • 1 reply
  • 1118 views

Need an improvement in NX PMI conversion for the Multi-byte character in the future release of Creo View and Creo View adapter for NX.

Based on the comments in the chapter of Supporting NX with Model View States in 5.1 F000 Crreo View MCAD Adapters Installation and Configuration Guide

  • NX PMI conversion has the following limitations: No Multi-byte character support. Only ASCII characters in PMI annotations are converted.

 

    1 reply

    V
    24-Ruby III
    VladimirN24-Ruby III
    24-Ruby III
    August 20, 2019

    You can bring your idea in "Creo Ideas" area, here: https://community.ptc.com/t5/Addtl-Creo-Ideas-Creo-View/idb-p/creogeneralideas

    Terms & ConditionsCookie settingsAccessibility statement