Skip to main content
J
JamesBurcham1-Visitor
1-Visitor
March 25, 2014
Question

PTC Creo Sketch?

  • March 25, 2014
  • 2 replies
  • 949 views

Has any used PTC Creo Sketch? I'm wondering what people think of it. I've seen a little online about its capabilities, but I'm wondering how practical it is.

Any thoughts would be welcome.

2 replies

N
neomechanikos1-Visitor
1-Visitor
March 25, 2014

I've found it's a really good tool. It even has layers (Sketch 2.0) and vector based tools. I haven't had a project yet to practice on but looking forward to using it. I'm an engineer, not an industrial designer so take my opinion with a grain of salt. Sketch 1.0 was very limited so I never played with it much.

V
24-Ruby III
VladimirN24-Ruby III
24-Ruby III
March 26, 2014

You can check this video tutorial: http://learningexchange.ptc.com/tutorials/by_sub_product/ptc-creo-sketch/sub_product_id:17

Terms & ConditionsCookie settingsAccessibility statement