Solved
License request failed for feature
I installed creo parametric, but when I attempt to open the program I receive an error message, "License request failed for feature." How is this resolved?
1. Articles:
- "Error "License request failed for feature" occurs while launching Creo Parametric": https://www.ptc.com/en/support/article/cs369394
- "Error message "License request failed for feature": https://www.ptc.com/en/support/article/cs26888
- "Getting the error: "License request failed for feature Invalid feature name:[FEATURE_NAME]" after launching Creo Parametric": https://www.ptc.com/en/support/article/cs349225
2. "Guided Licensing & Installation Troubleshooter for PTC Products based on FlexLM": https://www.ptc.com/en/support/creo-admin-troubleshooter
3. There was a similar question before - "Error message "licence request failed for Feature"": https://community.ptc.com/t5/PTC-Education-Forum/Error-message-quot-licence-request-failed-for-Feature-quot-CREO/td-p/641797