Skip to main content
ptc-66879161-Visitor
1-Visitor
October 10, 2014
Solved

Modelling a suction cup

Is is possible in Creo Parametric to motion model the flexible part of a suction cup?

Thanks in advance.

Steve

    tbrotherhoodAnswer
    12-Amethyst
    October 12, 2014

    Steve,

    Is this what you are after? The offset of DTM1 controls the 'squash' of the cup shown below as a section.

    Up.PNG

    Down.PNG

    Model attached.

    View in thread

    1 reply

    tbrotherhood12-AmethystAnswer
    12-Amethyst
    October 12, 2014

    Steve,

    Is this what you are after? The offset of DTM1 controls the 'squash' of the cup shown below as a section.

    Up.PNG

    Down.PNG

    Model attached.

    Translate
    Terms & ConditionsAccessibility statement