Skip to main content
ErickM1-Visitor
1-Visitor
Nov 8, 2010 2:58 PM UTC
Question

Problem with FloEDF

I am trying to run some mock analysis on a wing design to get familar with the program. When I try to run FloEDF's wizard it starts to load but then give me an error of "There must at least one component for a FloEDF.Pro analysis." Can you help me figure this out?

Attached is a screen shot of what I am trying to analyze and the message that keeps popping up.

    2 replies

    RodPierce1-Visitor
    1-Visitor
    Nov 8, 2010 6:06 PM UTC

    Do you have an assembly open in ProE?

    Translate
    mfischer18-Opal
    18-Opal
    Nov 8, 2010 6:57 PM UTC

    Hi all,

    To run a flow analysis, you need to do a number of things prior to running it.

    1) Flo can only work on an assembly

    2) Flo can only be used on solid components

    3) you need to save the object prior to running the model

    4) you need to make sure the model is fully regenerated.

    Please give those items a check and try and run it again.

    If it fails....send the model to - and I can take a look.


    Regards,

    Mark

    Translate
    Terms & ConditionsAccessibility statement