Skip to main content
ptc-68209071-Visitor
1-Visitor
December 29, 2014
Solved

Problem with holes and checkmark

I am using Creo 2.0 Parametric for building an FTC robot. I have already designed a wheel but when I put in the center axle hole the check mark is grey and won't let me apply the changes. Any suggestions?

    sm_01Answer
    1-Visitor
    February 24, 2015

    When placing a hole at the center of another round object, I like to reference the axis of the existing round object and the plane where the hole starts. Define depth as needed and you should be good-to-go.

    View in thread

    2 replies

    ptc-48274811-Visitor
    1-Visitor
    January 2, 2015

    Make sure the hoe is properly constrained-- ie, you have the location properly fixed and there aren't any of the green handles floating around.

    Translate
    sm_011-VisitorAnswer
    1-Visitor
    February 24, 2015

    When placing a hole at the center of another round object, I like to reference the axis of the existing round object and the plane where the hole starts. Define depth as needed and you should be good-to-go.

    Translate
    Terms & ConditionsAccessibility statement