Creo 2 M060 Install destination folders

Question

Happy Monday All,When installing or updating an existing install of Creo 2.0 from F001 up to M060 I find that in some cases it will go into the Program Files folder and other times it will end up in Program Files (x86).M060 first time installs have been going to Program files but some upgrades that are initially in Program files (Mostly F001 or M020) will go to Program Files (x86). I would appreciate any insght as to why this happens.Thank In Advance,Bob LohbauerJacobs Vehicle SystemsThis thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

iceblink1 · Answer

On 2013-07-22 15:49, Bob Lohbauer wrote:
> Happy Monday All,
>
> When installing or updating an existing install of Creo 2.0 from F001
> up to M060 I find that in some cases it will go into the Program
> Files
> folder and other times it will end up in Program Files (x86).
>
> M060 first time installs have been going to Program files but some
> upgrades that are initially in Program files (Mostly F001 or M020)
> will go to Program Files (x86). I would appreciate any insght as to
> why this happens.
>
> Thank In Advance,
>
> Bob Lohbauer
>
> Windchill Administrator
>
> Jacobs Vehicle Systems

On 64-bit systems 32-bit software gets installed into "Program Files
(x86)" and 64-bit software gets installed into "Program Files".

You may have a mix of 32 and 64 bit systems. Or you may have a mix of
32-bit and 64-bit installation software.

Best regards,
Patrick Asselman

Sign up

Please use your PTC eSupport account.

Welcome to the PTC Community

Please use your PTC eSupport account.

Scanning file for viruses.

This file cannot be downloaded