Creo 3.0 M040 - 3D printing licence

Hello,

l have a question about 3D printing "module/function" in Creo 3.0 M040. See following link from PTC:

Is it a standard function in "standard licence"? Or does it require some special licence?

Thanks in advice

Milan Bonka

Best answer by MartinHanak

I hope, no additional license is needed.

Martin Hanak

Answer

24-Ruby III

I hope, no additional license is needed.

Martin Hanak

1-Visitor

Hey guys,

Just a question, MartinHanak‌, was your hope confirmed with a solid answer from PTC or your PTC Channel partner?

If not, perhaps this question should not be marked as correctly answered?

- Jim

24-Ruby III

Jim,

you can ask PTC, if you want . I didn't any information referencing additional licensing in https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS207725

MH

Sign up