Question
New .dtl file for Creo 2.0
- August 24, 2012
- 0 replies
- 794 views
Going through the update training I noticed a new configuration file you might skip over it without realizing the significance.
There are now .dtl files for drawings and models. Two separate files with different options.
There is a new config that controls where this file is:
model_detail_options_file <creo_loadpoint>\text\3d_inch.dtl
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
There are now .dtl files for drawings and models. Two separate files with different options.
There is a new config that controls where this file is:
model_detail_options_file <creo_loadpoint>\text\3d_inch.dtl
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.